Page 1 of 1
GPS Port Is not recognized
Posted: Thu Nov 18, 2010 6:15 am
by ehsandavarynejad
Hi,
My PDA communicates GPS form port com:4, which is not listed in settings of I-tree, How can I solve this?
GPS not recognized
Posted: Thu Nov 18, 2010 11:32 am
by azelaya
Hello,
Can you verify if you activated GPS in the project configuration on your desktop before sending a project configuration to the PDA. There is a check box for GPS on the Input- Data Fields option of the desktop that must be checked so that GPS functionality will be enabled in Streets. This will allow you to scan available port and enable a drop down allowing you to choose a com port. Al
Re: GPS prot dose not recognized
Posted: Sun Nov 21, 2010 8:15 pm
by MJKerr
ehsandavarynejad wrote:Hi,
My PDA communicates GPS form port com:4, which is not listed in settings of I-tree, How can I solve this?
In the GPS control panel of the PDA, select COM4 as the hardware port and use another COM port as the program port. Check the box "Let Windows handle my GPS devices," re-launch Streets PDA, and try again. This is assuming you have GPS enabled in Streets. A reboot of the device might be required.