Hello guys,
was wondering as i have a project where it is not possible to enter the area and plots are not given. There are just the Trees given. it is possible to run the model, but what does the model assume the trees are just next to each other ?
Is it possible to change the Area ? >The button is grey so does not work not even in editing.
Thanks for ideas
Project and Strata Area
Moderators: i-Tree Support, i-Tree Team
-
hannses helly
- Posts: 8
- Joined: Wed Sep 21, 2022 7:36 am
-
hannses helly
- Posts: 8
- Joined: Wed Sep 21, 2022 7:36 am
Re: Project and Strata Area
Hey,
as i was thinking to much about other stuff i realized in complete inventory the assumed area is the measured ground,
This was due to i imported the data from a plot based inventory. And then thought where is the plot are.
as i was thinking to much about other stuff i realized in complete inventory the assumed area is the measured ground,
This was due to i imported the data from a plot based inventory. And then thought where is the plot are.